PANASONIC 3400mA BATTERY & CHARGER FOR THE MINELAB SOVEREIGN XS & 2A PRO

Description

Panasonic
3400mah
Li-ion battery pack for the Minelab Sovereign XS PRO,  XS 2A PRO & XT18000 metal detectors.  Over 5X the capacity of the original factory battery...plus made with premium Panasonic Japan manufactured cells.
EASY MODIFICATION FOR YOUR XS PRO, 2A PRO & XT17000 , XT18000
HOW TO MODIFY YOUR MINELAB XS PRO AND XS 2A PRO
1) INSIDE YOUR BATTERY COMPARTMENT REMOVE YOUR CONTACT PLATE- CUT WIRES FROM THE BACK
2) CAREFULLY REMOVE THE FRONT AND REAR HOUSING SCREWS (XS 2A PRO ONLY HAS 2 REAR SCREWS)
3) EASE THE FACE PLATE ASSEMBLY OUT .
4) THERE ARE TWO ROUND HOLES IN THE BATTERY COMPARTMENT - CAREFULLY DRILL EITHER ONE WITH A 11/32 BIT AND INSERT THE RED CONNECTOR THRU THE HOLE.
5) TIE A COUPLE OF KNOTS IN THE WIRE INSIDE THE BOX SO YOU CANNOT PULL THE WIRE BACK OUT- GIVE ENOUGH SLACK SO YOU CANNOT PULL THE PLUG OFF THE CIRCUIT BOARD.
5) REMOVE THE OLD CONNECTOR FROM THE CIRCUIT BOARD AND INSTALL THE NEW RED CONNECTOR, SEE PICTURE.
6) INSERT THE FACE PLATE ASSEMBLY BACK IN PLACE (MAKE SURE THE 5.5X2.1 CONNECTOR REACHES THE END OF THE BATTERY COMPARTMENT AS THIS MAKES IT EASIER TO INSTALL THE BATTERY.
7) RE-INSTALL THE HOUSING SCREWS AND YOU ARE DONE!
FAST USPS PRIORITY SHIPPING
Not a cheap imported pack- Manufactured right here in the
U.S.A.!
LISTING INCLUDES
Minelab 12v 3400mA battery
12V 700mAh Charger with LED indicators
Input Voltage:100-240V , 50-60Hz
New Sovereign cable assembly
FEATURES:
Cells: Panasonic Li-ion 18650 PCB Li-ion
Built in PCB circuit protects the battery from overcharging or discharging!
Voltage- 12v (3 cell)
Capacity- 3400mah
Size- L 2.88" x W 2.25" x H .75"
Battery weight- 5.5 oz